What was today's Sling project-Mods , goodies....?
-
-
Funinthesun really! Do they explode?
Because I don’t have a hood or dash for protectionLike wokka said they just crack at the seem. This is usually because of heat off the exhaust. But, with yours being wide open I don't think you'll have an issue.
-
Funinthesun wokka WraithSS thanks for the heads up guys!!
Speaking of heat, Today I drove home from work, turned off the motor, and grabbed the radiator outlet pipe with my hand. It was pretty close to ambient air temp! I was a little shocked... -
Funinthesun wokka WraithSS thanks for the heads up guys!!
Speaking of heat, Today I drove home from work, turned off the motor, and grabbed the radiator outlet pipe with my hand. It was pretty close to ambient air temp! I was a little shocked...Next time, feel of your water surge tank, it's right above and behind your turbo, so it may be a bit hotter. Heat and age just cause problems, and the DDM tank looks really good vs the plastic one.
-
-
Like wokka and WraithSS said, they just crack. Either at a seam or the lower nipple breaks off due to the tension of the attached hose. Either way, a metal tank looks a LOT neater and is a lot safer and eliminates a long walk home when the oe one breaks on a long weekend ride in the mountains with no cell phone service
-
wokka Good idea ☝️ I’ll check the tank temp tomorrow 🤔
Also got to see if I can swing by a scrap yard to weigh this beast!Just don't let the 'boys' there get there hands on it.
-
I just noticed that you still have to stock coolant tank. You might want to upgrade it to the one that DDM sells. The original plastic tanks from Polaris have a history of failures at the worst possible time
Oh, great! Something else I didn't know I had to worry about... lol
-
Oh, great! Something else I didn't know I had to worry about... lol
One of the problems with the tank was the firewall brackets were around 3/16 of an inch too close together putting unnecessary external pressure on the tank. Mine split at the seam at the center most bolt.
-
I might be alright with the external stress...
I’ll check the coolant tank heat after next ride...
-
I might be alright with the external stress...
I’ll check the coolant tank heat after next ride...
Those two bolt brackets holding the tank is what I an talking about. On the 2015 they are too close together for the tank holes. I have not checked the 2016 Sling yet.
-
I do have the master cylinder brace on my list of possible things, but frankly I have never felt as if my breaks were bad - - Of all of the mods I have done the only one I probably do differently would be the Sport Top - - its a great top, but I just dont use it enough. Patrick's more portable option the quick shade would be my choice today if I were to do it again
brakes is one of those thing that you don't want to wait until you need them, mine have always been fine but just hearing other slings had issues(back in the early days there were a lot of issues with some) was enough for me to add the MC brace ,change the pads and flush the fluid yearly.
-
brakes is one of those thing that you don't want to wait until you need them, mine have always been fine but just hearing other slings had issues(back in the early days there were a lot of issues with some) was enough for me to add the MC brace ,change the pads and flush the fluid yearly.
That sounds like a good maintenance plan. What pads did you replace the stock pads with? How do they feel?
-
Those two bolt brackets holding the tank is what I an talking about. On the 2015 they are too close together for the tank holes. I have not checked the 2016 Sling yet.
This made me so curious, I had to go out and check... lol I believe mine are good to go, but then again, my Sling only has a few miles on it. What I'm curious about though, is why your coolant is green and mine is red? Any idea what's in mine and what are you running in yours?
-
This made me so curious, I had to go out and check... lol I believe mine are good to go, but then again, my Sling only has a few miles on it. What I'm curious about though, is why your coolant is green and mine is red? Any idea what's in mine and what are you running in yours?
You cannot tell the difference by looking unless you are trying to install a new tank. As to the anti freeze color it could be a different brand, but the Prestone Dex-Cool is red. One off those oil change places messed up my cooling system by mixing some of that any thing/kind will work/mix. From then own I use only Dex-Cool. If you do not have the right stuff DO NOT add anything to my coolant system. Dex-Cool is what you use in your cooling system if anything or any part is aluminum. Enough Said
-
You cannot tell the difference by looking unless you are trying to install a new tank
I see. Well, I'll add the after market tank everyone's talking about to my list of future upgrades. Thanks
-
I see. Well, I'll add the after market tank everyone's talking about to my list of future upgrades. Thanks
It is better to made the change than the tank start leaking when you are out of town and no replacement is available. But I would bet you that DDM or SlingMods would overnight you a new tank
-
Not really a mod, but finally got this baby put on. Now, it's time for a short drive to see how she breathes... I figure about 75 miles ought to do it? 😎
-
This made me so curious, I had to go out and check... lol I believe mine are good to go, but then again, my Sling only has a few miles on it. What I'm curious about though, is why your coolant is green and mine is red? Any idea what's in mine and what are you running in yours?
His is probably not ripe yet and yours is
-
Hi guys, I know it's been a while, hope all is well. Added a couple goodies on the sling. A little CF on the mirrors.
A little CF inside panel. This was a pain in the butt. None of the holes lined up. Could be just mine. I have 1 of the first slings built so quality wasn't the best and screw hole could have been off. Once I egged the holes out, it was fine.
The last thing I added was the lower insert on the side. Again, holes did not line up but after I egged them out, it was fine.