It was hot. Very hot
Just the fever from The Beast !
It was hot. Very hot
Just the fever from The Beast !
Hey @FunCycle the runs that you make , you could ride over , help for four hrs and drive home. Just a walk in the park for you. You Sir ,are a real rider IMHO
Maybe an over night run. Turned over 29,000 miles today, another oil change in another 500 miles. By the time that I got there @rabtech would already have it installed.
Maybe an over night run. Turned over 29,000 miles today, another oil change in another 500 miles.
You are a tough ridder .See you ina few weeks
To DDMWorks and back home.
So how long till you have that puppy installed?
I have the beast's first meal.
So how long till you have that puppy installed?
I may try to start on it tomorrow.
Where is the engine on the dining room table?
Sitting in that fancy chair of his.
Display MoreNice!!!!
@Dave@DDMWorks tell me, what is your method to torque the camshaft bolts?
I was always ending up getting the chain skipping cogs while angle torqing mine, I had to try multiple times to finally get it done.
I was alone holding the cam and torqing maybe if you 2 its easier...
2 is better than 1 in that scenario but I am usually able to do it on my own. Its a 23mm wrench to hold the cam shaft itself.
Just unbelievable how nice the DDM crew were today. I picked up @Wrenchmn in Atlanta and he rode over with me to pick this beast up. I thought I was going to have to lay down puppy pads down in the showroom floor. He was drooling everywhere. DDM has some showroom bling!
Glad you made it home safely, it was great to see you and @Wrenchmn again, we are very happy that we were able to help you with this part of your build and look forward to you getting the engine installed, tuned and running strong. If you have any questions along the way with the engine swap, just let us know Also looking forward to hearing how @Wrenchmn his new toy that he picked up yesterday
I may try to start on it tomorrow.
I Think I just heard it start up!