Now that’s what I am talking about. Looks good,maybe put the outside amber. What do you plan for front side toward tire, slope or square?
Hang in there you'll see, it will match.
Now that’s what I am talking about. Looks good,maybe put the outside amber. What do you plan for front side toward tire, slope or square?
Hang in there you'll see, it will match.
Awesome!!!!!
The extra LED on the outside adds a "European" touch too!!
@mytoy, my dealer warned that LEDs can interfere with computer communications from various sensors....so maybe before making permanent light installations.....install them in a temporary manner and drive it for a while to make sure they don’t cause any problems....especially if the lights involve making holes in parts that can’t be fixed if the lights don’t work out...
@mytoy, my dealer warned that LEDs can interfere with computer communications from various sensors....so maybe before making permanent light installations.....install them in a temporary manner and drive it for a while to make sure they don’t cause any problems....especially if the lights involve making holes in parts that can’t be fixed if the lights don’t work out...
I installed the one in front already no problem, and there a hundreds out with all kinds of LED's, and I'll install a separate blinker relay.
If I would always be concerned with stuff I would have left it STOCK and on top I would have purchase a slow grey one just to be sure,
I don’t think the actual LED bulbs are the issue but the sequencers/blinker modules and some bulbs come with resisters on them..I think any electronic interference if there is any originates more from them...than the light bulbs....but isn’t the LED an actual mini circuit board? Many laptop/desktop Computers have conflicts from adding hardware...and software...
And I’m considering drilling some holes and if the modules cause problems, what do you do with the holes.....that’s all I’m saying..
I don’t want my SS to look like a tractor trailer covered in running lights all over it..
I don’t think the actual LED bulbs are the issue but the sequencers/blinker modules and some bulbs come with resisters on them..I think any electronic interference if there is any originates more from them...than the light bulbs....but isn’t the LED an actual mini circuit board? Many laptop/desktop Computers have conflicts from adding hardware...and software...
And I’m considering drilling some holes and if the modules cause problems, what do you do with the holes.....that’s all I’m saying..
I don’t want my SS to look like a tractor trailer covered in running lights all over it..
Actually I'm considering not to post anything about what I'm doing till it is done.
Actually I'm considering not to post anything about what I'm doing till it is done.
Keep doing what you do my friend
If you notice 99.9% of us are with you.
I for one am waiting to see the final design.
@mytoy, my dealer warned that LEDs can interfere with computer communications from various sensors....so maybe before making permanent light installations.....install them in a temporary manner and drive it for a while to make sure they don’t cause any problems....especially if the lights involve making holes in parts that can’t be fixed if the lights don’t work out...
Keep doing what you do my friendIf you notice 99.9% of us are with you.
I for one am waiting to see the final design.
@MACAWS welcome to the senior club you reached 100,000.00 + and you did not even know it, cant wait to visit you and your honey in Clarksville again. +
Here is a new rendering with a few changes, added two amber LED'S, one red, angled surface so water runs off, and slant towards the wheel. I should get the new splash guards soon so I can measure correctly and make the prototype.
Lookin good Dieter. Keep up the good work
Looking very good!
Yes! I just ordered more MODS
Just received the new splash guards, soon measuring and proper design can begin
Just received the new splash guards, soon measuring and proper design can begin
If you do not mind, what did they cost?
If you do not mind, what did they cost?
$ 114.26 each