I have a question about wiring up my new heated PRP seats. I am lucky enough to have a 2016 Sling that already has the wiring for the heated seats installed from the factory just as it does for the fog lights that I have already hooked up and it was really easy. I have hooked up a multi-meter to the plug under the seat and when the ignition is on and the engine is off I am getting about 9-10 volts so I know the other end is hooked up to something. I am just looking for some help in the best, easiest and safest way to get the heated seats working. I do have waterproof switches that fit in the dash under the display so that is no problem.
My current plan is to cut off the plug on the PRP seats and attach it to OEM harness so I can plug into the existing wiring on the PRP seats. This brings me to my questions:
1.
Do you know if there is a plug adapter available so I do not have to cut the current wires from the Sling and install the PRP seat plug?
2.
Can you tell me where the other end of these wires come out in the front of the Sling? I was thinking about hijacking them and moving them to the 2 waterproof switches that I already have and can mount in the dash under the display screen then just Loom back over to my FX-1 Fuse Block separately with 10 amp. fuses for each.
In my travels I have been told that DER Doc&Ruby ericastar76 Might be able to assist.
Any input/suggestions would be greatly appreciated.
Happy Sling'n!