sure, if you go with that - just like a Haltech - but that is not what this thread nor the previous links are about
OBD2
-
-
It appears you are correct. I didn't read that far into it. It looked like just a diag tool to me. Looks interesting, but I would be afraid to go in there and play with tuning an ECM without knowing what I am doing. I think I'll leave that to an expert...
-
-
Update check engine light.
I took it out on Sunday ( full tank of fuel)and no check engine light ( good 50 to 60 miles). I took it out today after work and the check engine light came on (3/4 to half of fuel tank). It’s ran fine. -
Others have reported this as Clutch switch signal / Data Erratic, Intermittent or Incorrect.
-
Thanks, I hope its just a switch.
-
Which product is best for the OBD hook up and will it erase codes?
I have a 2015
-
OBD will not work in a Sling. They use a totally different system.
-
It’s not OBD, it’s MEFI
Sent from my iPhone using Tapatalk Pro
-
Check with Mefiburn.com
Sent from my iPhone using Tapatalk Pro
-
Thanks for the fast response. So purchasing one from OBD Diagnostics (MEFI 6 Scan) would be a wrong move? I hate to make a costly mistake.
-
Call them. His name is Bob and he goes most all the sling tuning. He is very knowledgeable .
Sent from my iPhone using Tapatalk Pro
-
Thanks for the fast response. So purchasing one from OBD Diagnostics (MEFI 6 Scan) would be a wrong move? I hate to make a costly mistake.
That should work (http://mefiburn.com/mefi6scan.asp), although I don't know how much of the ECU is accessible using that software. Polaris encrypted/scrambled the ECU output format and it took a while for Bob MEFIburn to figure things out. While he has developed improved tunes for normally aspirated and turbo-specific Slingshot setups, I don't know if the software can read everything the ECU does. That would be a good question to ask Bob.
Also, while several different websites have been mentioned in this thread, each is a different company with separate addresses.
OBD Diagnostics - http://www.mefiburn.com
MEFI Pro, part of CBM - https://www.mefipro.com/index-mpro2.html
-
Call them. His name is Bob and he goes most all the sling tuning. He is very knowledgeable .
Sent from my iPhone using Tapatalk Pro
Thanks Again WingShot! Talked to Bob earlier. Now I need to search for the right 1320 Header to replace the Factory header.
any heads up on that would be helpful. Also do I need an exhaust pipe or muffler on that?
I’ll send in the ECM for Bob to flash after that. -
Call Dave at DDMworks.com. He is up on latest pipes.
I run turbos on both mine. Good choice on using Bob he knows his tuning.
Sent from my iPhone using Tapatalk Pro