Looking good !!
I know where those Alpha boxes were headed!
-
-
The white looks incredible but I think if you strip and redo it just one more time it will be perfect.....
-
-
The white looks incredible but I think if you strip and redo it just one more time it will be perfect.....
Not funny..... I still have two cans of Aircraft Remover on the shelf..... -
-
THAT is sexy!!! I may need a smoke and some quiet time after this!!!!!!!!! Just hold me!!
-
I feel like I'm looking at an automobile version of Johnny-5!
Johnny-5 alive!!!
-
I don't like anything shiny.
I wish my fiance' had the same problem.
-
@rabtech are those Clearwater Darla LED's in the Canadian slots? -
@rabtech are those Clearwater Darla LED's in the Canadian slots?
Nope. they are 30.00 a set LED tractor flood lights. They fit perfect and are super bright. They light up the ditches and all the front of the SS very well. When I found them I just got lucky on Ebay.
-
Cool, thank you!
-
-
-
@rabtech
What kind of exhaust gasket did you use between the header and down pipe? I am connecting up a Alpha side exit and 1320 header which are both flat surfaces.Alpha side exhaust comes with the proper gasket, it is a metal gasket. That is the same setup as mine and never had an leakage.
-
Yes I agree and I've even reused mine a second time with no issues what so ever.
-
Need to look in the box a little harder when I get home. I didn't see one.
-
Need to look in the box a little harder when I get home. I didn't see one.
It should be tyrap to the flange in the correct bolt orientation.
-
The connection between header and the exhaust may be like the turbo to the exhaust... it doesn't have a gasket. Just two machined surfaces.
-
I just checked the box and the exhaust. There is not a gasket to be seen. Both surfaces are machined flat, I'll give it a try. If someone has a picture of what the gasket looks like could they post it just in case it does not seal.
If needed I can probably source one from NAPA.
Thank you -
@Slingrazor you should be able to use the factory gasket that came off your old muffler and manifold connection. I was able to reuse mine when I replaced my Alpha side exit with no problem what so ever.