My driver side fender rattles whenever I go over a bump. The passenger side doesn't rattle. I purchased and installed the rubber hood cushions but I still have the rattle. Have had this for over two years since new.
Anyone have some advice on how to correct this annoyance?
Are you sure it is the fender? The bolts holding the front clip together are known to come out. I just took the front clip off last week and there were two bolts were out.
My driver side fender rattles whenever I go over a bump. The passenger side doesn't rattle. I purchased and installed the rubber hood cushions but I still have the rattle. Have had this for over two years since new.
Anyone have some advice on how to correct this annoyance?
the rubber pads won’t stop the rattles.....
do you have things that look like this under the hood near the turn signals
top is rubber about an inch think and there are adjustment threads sticking out of it. With locking nuts. These adjust up to keep the fenders from flapping...
Didn’t Polaris eliminated these in a recall ...for the pads...and small inch round rubber dots....
Didn’t Polaris eliminated these in a recall ...for the pads...and small inch round rubber dots....
Different part. They replaced the larger rectangular adhesive hood pads with rubber bumpers...
Speaking of the hood/fenders flapping, this has not been an issue with our 2015. Our dealer at the time told us that one of the changes for the 2016.5 model was a redesigned lighter hood, and as I recall, this seems to be about the time when flapping became an issue. Is there any truth to this?
Bill
Bill I think even the 2015 "early ones" flapped a little. Mine (2016) does in certain conditions and speeds over 75mph. The guys at the dealership keep things in good order for me when something's not quite right.
Bill I think even the 2015 "early ones" flapped a little. Mine (2016) does in certain conditions and speeds over 75mph. The guys at the dealership keep things in good order for me when something's not quite right.
Yep, agreed, when conditions are exactly right, but it is far from being the consistent problem as apparently several owners have?
Bill
Different part. They replaced the larger rectangular adhesive hood pads with rubber bumpers...
these are up near the windshield....mine had to be shortened to allow the Hood to sit lower to make the body lines match....the rubber in the picture on mine has only half of the height.
