I was thinking of making my own...Did you make one?
I used my broken DDM Works splitter as a template. I made a small change by hot gluing extensions on the tips of the DDM Splitter, like I showed earlier in this thread.
I drilled all the bolt holes through my sheet of plastic, and bolted the two together using binding barrels. Then I used a flush trim router bit to cut it out.
This bolt pattern guarantees, excellent sparkage when dragged!😜
To be honest almost every bolt on my splitter showed damage from scrapping, and I am still at the stock ride height. Some is my fault from turning so hard into banked turns, but the roads here in PA suck. I never hit any parking lot curb stops or anything like that.
To be honest almost every bolt on my splitter showed damage from scrapping, and I am still at the stock ride height. Some is my fault from turning so hard into banked turns, but the roads here in PA suck. I never hit any parking lot curb stops or anything like that.
that is more than I can say🤣
I hate rocks and road debries!!! You did a great job!!!
here's a pic for you & since I have nothing to do , I'm out time to hit the road for a cruise......only have a few hrs lmao
here's a pic for you & since I have nothing to do , I'm out time to hit the road for a cruise......only have a few hrs lmao
I'm going out for a little ride shortly. Sunny and 45 ... rain tomorrow.
