I’m starting to plan out my first LED light install. I’m going to run a single color under the sling shot that I want to turn on an off with a toggle switch. I may want to add interior lights. I’d like to use a water proof fuse block under the hood in case I decide to add something else in the future. Can anyone show me where they mounted their fuse block? Also where are you mounting your toggle switches?Thanks Todd
About to plan a light install
-
What year SS?
I used a stock switch on my stereo face plate (2019). It's the 2nd one from the left below. Some people have put switches in the steering wheel cover or there is a switch plate available from Slingmods that puts them to the left of the steering column:
Be very careful not to mount the LEDs on the bottom of the frame - speed bumps will kill the lights. Even with mounting them on the side of the frame, you still have to go around cross members. I eventually pulled all mine out after replacing them every time I turned around.
There is a triangular spot right in front of the driver in the engine bay to the outside of the brake reservior that most people put the fuse blocks. I prefer the FZ-1 from Slingmods because it is switchable on-the-fly (no rewiring needed) between always on and ignition switched. You can even run both at the same time on different circuits.
-
for the fuse block, I ran in in the space behind the drivers side front tire and then got covers to go on it. For a switch you can order a switch that will be ignition toggled from Polaris.
-
Pics or it didn't happen....
-
Pics or it didn't happen....
I mean it is the thread right underneath this one... Doing light mods
