I looked through the DIY section, and couldn't find anything on this. I would like to remove the drive and swing arm as one piece if that is possible. I know I have to loosen the belt up and et it off and I am assuming the 30 mm bolt needs to come off. and the hex head bolt on the battery side needs to come out. is that right. once I remove the bolts to adjust the belt and then remove the drive shaft that looks like that is all holding it on is the swingarm shaft. is that right??
Angle Drive / Swingarm removal.
-
I haven't done this job but the only thing I see you're missing is the shock removal but don't believe it will come out as one piece. Angel drive is a independent unit.
Probably should tag some of the quad builders... kev. Dave@DDMWorks
You guys got any insight
-
.....its 2 pieces....swingarm & angle drive ....i just removed one and yes once you remove the shaft bolt , the swingarm will lower but the angle drive has 2 side bolts holding up on the frame, hopes that helps....
-
Yes sir it does thanks, I know the shaft bolt is a 30 mm what did you use fir the hex part by the battery?
....22mm hex
-
I haven't done this job but the only thing I see you're missing is the shock removal but don't believe it will come out as one piece. Angel drive is a independent unit.
Probably should tag some of the quad builders... kev. Dave@DDMWorks
You guys got any insight
yah , I see Madmoe already explained the front swingarm main cross bolt has to come out of the frame mounts then the two pieces will separate, and yes the only way to get it out is with that 22mm hex head to fit on your 1/2 inch ratchet extension and while most guys have a 1/2 '' ratchet at home , a trip to the local hardware tool shop, will usually be required for the 22 mm hex bit socket
-
-
I used a spark plug socket backwards which is 22mm put that in then i put the extension in and used a ratchet and unscrewed it right out with no problem at all
-
oh I like how you think. Smart
