I figured I'd start a thread for any questions that come up while I'm finally trying to get my Hahn turbo installed.
First question is about using Teflon on the drain fitting connecting into the oil pan -
The Hahn turbo instructions don't specify using Teflon on the drain fitting that connects into the oil pan while the Alpha instructions do. I assume Teflon should be used. I know NOT to use Teflon on the flare fittings! I test-fit the fitting and while I didn't fully tighten it, it looks like it will take a decent amount of force to get the fitting aligned upwards to meet the drain hose coming down from the turbo.
Second question is about getting fittings into hoses -
Is there a trick beyond using silicone spray to make it easier to get the fittings onto the drain hose? When I first tried using just the silicone spray, I could only get the fitting about halfway into the hose. Guess I spent way too much time behind a desk when I was working. I'm now considering using hot water to hopefully soften the hose first, then silicone spray and plan on using compressed air to make sure the hose and fittings are dried out before installing the hose.
Any help appreciated!