I know where those Alpha boxes were headed!
-
-
Here is one of my favorite things. You can get to the manifold bolts with ease...
-
Looks to me like a well thought out design
-
Here is one of my favorite things. You can get to the manifold bolts with ease...
I am just jealous that is beautiful.
I would be more active but where I am it takes over 1 minute for a page to load -
Dondé esta?
-
Here is one of my favorite things. You can get to the manifold bolts with ease...
That beats my knuckles getting beat up with that 1320 ... I still feel the pain. NICE job Rab.
-
Question ,... I have two o2 sensors bungs. One is in the header that is before the turbo and one is right after the turbo in the muffler section. Do I install the narrowband sensor before the turbo and the wideband sensor after the turbo?
the OEM o2 goes in the header. Wideband goes in the muffler
-
Henry
Is there a conversion to use that header and muffler set up on any other system?
I am guessing the turbo will not line up.I am just looking to get more exhaust flow and turn down the noise
-
Ok. Here is how close we are to matching up with the oil return line. It's going to require a bit of modification work. But I believe it will work....
-
Another shot of it. I will have the center section of the turbo in the next pics.
-
I haven't fell off rhe face of the earth. I am having to work out this oil return line.
-
-
Cause u can't gravity feed oil uphill..
-
The hole in the block is lower than the bottom of the turbo. And that is a good thing. But the AN fittings are causing the heights to be bassakwards... so I'm hunting some low profile fittings.
-
I have fittings.
-
-
And 10' of braided line. Probably enough to do 50 turbo kits.
-
Henry
Is there a conversion to use that header and muffler set up on any other system?
I am guessing the turbo will not line up.I am just looking to get more exhaust flow and turn down the noise
it won't be a direct bolt on since your turbo is in a different position.
-
it won't be a direct bolt on since your turbo is in a different position.
Any plans for a conversion kit or is too complicated.
-
we would have to have a as here with a Hahn kit to mock up and build a jig