Does anyone know where I can tap into the engine block to supply a turbo on a Gen 3 block?
Oil supply location on a Gen 3 block for a turbo.
-
I think Dave@DDMWorks & Kyle D (ZZP) tap into the engine oil pan below the front end.
-
Does anyone know where I can tap into the engine block to supply a turbo on a Gen 3 block?
The Gen 3 block obviously does not have the ports on the side to get oil from like the other blocks. We will use the port on the back of the cylinder head, or drill and tap the back of the block where the oil filter housing is located.
Dave
-
I think Dave@DDMWorks & Kyle D (ZZP) tap into the engine oil pan below the front end.
Thanks, but i drilled and tapped the block for the return. I need to find a supply as the gen 3 is different than mynold gen 2.
-
I think Dave@DDMWorks & Kyle D (ZZP) tap into the engine oil pan below the front end.
The Gen 3 block obviously does not have the ports on the side to get oil from like the other blocks. We will use the port on the back of the cylinder head, or drill and tap the back of the block where the oil filter housing is located.
Dave
Thanks, but i drilled and tapped the block for the return. I need to find a supply as the gen 3 is different than
-
I see 3 ports if I'm looking in the right place. 1 under each of the camms and 1 in the middle down a bit lower. Are these what yourtalking about?
