Polaris Slingshot Forum
The #1 forum for everything you need to know about the Polaris Slingshot.
Recent Activities
-
SlingSC
Liked ConnMan’s post in the thread My Slingshot just died.Like (Post)That's so frustrating!
Sorry Chav
-
SlingSC
Liked Sparcky’s post in the thread My Slingshot just died.Like (Post)Troubleshooting wiring is tough sometimes. By switching relays around and the problem not following, that should eliminate a bad relay. Intermittent before but not now, leads me to believe a bad/ intermittent connection that finally failed. You will… -
ConnMan
Liked billythekidd’s post in the thread Some Funny Comics I recently received in emails.Like (Post) -
ConnMan
Replied to the thread My Slingshot just died.PostThat's so frustrating!
Sorry Chav
-
Sparcky
Replied to the thread My Slingshot just died.PostTroubleshooting wiring is tough sometimes. By switching relays around and the problem not following, that should eliminate a bad relay. Intermittent before but not now, leads me to believe a bad/ intermittent connection that finally failed. You will… -
chavey2
Liked wokka’s post in the thread My Slingshot just died.Like (Post)Check Engine Code O 0520230 31
Since you checked the wiring already, my guess is an intermittent CB. -
chavey2
Replied to the thread My Slingshot just died.PostThanks. Yeah, that's one of the threads I found. But I am not leaving the key in the ignition - on or off. I always take my key out and put it in my cupholder or on the dash (usually dash) when it's in the garage. I have mistakenly left the key in a… -
ultrascott
Liked Sparcky’s post in the thread My Slingshot just died.Like (Post)(Quote from chavey2)
if push button start switch is not lighting up, I would start there and work back. If you can get access, it should be a 3 wire connector. Check for 12v between ground (bk/wh) and positive (pink) at the connector. Don’t jump… -
Bill Martin
Liked Edward Neal’s post in the thread Gibbs Rule #9.Like (Post)Got my Harpy today and I must say I like it. Its very different from my other Spyderco's - no screws, holding it together and no pivot bolt, just stainless steel and very smooth opening and closing - and my Lynch clip for it shipped today, think this is… -
Edward Neal
Replied to the thread Gibbs Rule #9.PostGot my Harpy today and I must say I like it. Its very different from my other Spyderco's - no screws, holding it together and no pivot bolt, just stainless steel and very smooth opening and closing - and my Lynch clip for it shipped today, think this is…