I was bleeding my breaks after I installed the TrakHamr and while I was doing this I noticed that only the front part of the reservoir was the only part that I had to keep filling up, the other half did not move. Is this normal or why did the rear not drain down as well. See how the front is clear and the rear still dirty looking? the front is full of new fluid, but the rear never moved.
Break reservoir question/bleeding brakes
-
-
The front is for the rear brakes / back is the front bakes
If you have access to a pressure bleeder that make life easier
Check out Motive Products
-
The front is for the rear brakes / back is the front bakes
If you have access to a pressure bleeder that make life easier
Check out Motive Products
thanks, that did cross my mind but wasn't sure if that was the case.
-
what size are the bleed valves on the calipers?
-
what size are the bleed valves on the calipers?
I am not real sure. It uses a 10MM wrench on the bleeder.
-
I wanted to buy speed bleeders since they worked great on my Goldwing but don't know the thread size.