@jorgebri60, next time you have to remove the seats just unbolt the belts from your seat and the transmission tunnel. Then slide them through the opening in the seat. Takes a lot less time and effort by leaving the harness attached to the roll bar.
MeanSling interior liner kits - Feed back wanted.
-
-
@jorgebri60 good feedback and thanks for the good write-up. Each sling will be a little different. As for the heat reduction I knew it would help but I'm not noting anything until I can get more validation. Your input helps me get closer to noting it. Glad you like them.
-
@jorgebri60, next time you have to remove the seats just unbolt the belts from your seat and the transmission tunnel. Then slide them through the opening in the seat. Takes a lot less time and effort by leaving the harness attached to the roll bar.
That’s exactly what I did. I just didn’t describe it well enough .
Thanks -
Pat,
It was 84 deg out today and sunny. IT MADE A HUGE DIFFERENCE in how much heat came I to the cockpit. From yesterday in the afternoon to today the difference is not only noticeable, but dramatic. Ya dun good !! @Ruptured Duck -
For the harnesses I only needed to remove the bolts holding the harnesses on the inside so that wasn’t too bad. The attatchment points on the rear deck were left alone.