I drilled the holes and slid the LEDs into them. I am going to RTV them in place. Originally, I was going to use them as just running lights. But I think that I was them to flash with the turn signal. What do I need to do that?
So, this is what I did Saturday
-
Looks good. I don't think I would have the patience to drill all those holes.
Sent from my SPH-L600 using Polaris Slingshot Forum mobile app
-
Holy guacamole...
-
I drilled the holes and slid the LEDs into them. I am going to RTV them in place. Originally, I was going to use them as just running lights. But I think that I was them to flash with the turn signal. What do I need to do that?
That is hard core....The easiest way is to buy a trailer light separator and use it to make a single wire (the light input) flash and have a solid appearance. You will want to use the brake light to power them in the running mode and then you will pull a signal from each turn signal and feed the module. It will make the brake (which is actually running lights) flash.
-
here is the module.
You will understand how it will work for you once you stare are it for a few mins.
