i bought a used swingarm without bearings and had it powder coated black,I’m installing all new bearings and adding a grease fitting for the pulley side needle bearing.my question is does anyone have the spec on how deep i need to install the pivot needle bearing? I’m not referring to the pulley side needle bearing,i know that one. I’m attaching a pic to show the one I’m needing,it’s #22. Thanks
Swingarm pivot bearing depth
-
-
i bought a used swingarm without bearings and had it powder coated black,I’m installing all new bearings and adding a grease fitting for the pulley side needle bearing.my question is does anyone have the spec on how deep i need to install the pivot needle bearing? I’m not referring to the pulley side needle bearing,i know that one. I’m attaching a pic to show the one I’m needing,it’s #22. Thanks
-
i bought a used swingarm without bearings and had it powder coated black,I’m installing all new bearings and adding a grease fitting for the pulley side needle bearing.my question is does anyone have the spec on how deep i need to install the pivot needle bearing? I’m not referring to the pulley side needle bearing,i know that one. I’m attaching a pic to show the one I’m needing,it’s #22. Thanks
You are correct, there is a measurement. But I have no idea what it is.
-
The instructions are not in the service manual. Also I cannot fid it any where else.
-
ultrascott punch up the thread "Grease Zerk in Axle/Swingarm" you may find some info there
-
I couldn’t find it in my service manual either. I have looked at the Zeke fitting thread and didn’t see it but will look again. I can always wait until i get my old one off and measure it
-
I couldn’t find it in my service manual either. I have looked at the Zeke fitting thread and didn’t see it but will look again. I can always wait until i get my old one off and measure it
In the very first post there are some measurements.
-
i went throught he comments again and don't see where there is a measurement for the bearing i need. they are all related to the pulley side needle bearing. thanks though
-
The instructions are not in the service manual. Also I cannot fid it any where else.
-
I’ve made some progress,have my axle side bearings installed and the zerk fitting installed.just waiting on my front bearings to come in.