Was in hopes to change out my top with a Gullwing, though if I was going to I wanted to to get a hole drilled in the support arm coming up from drivers side mirror mount where the front bar welds to it so that I could fish some wiring up into it. Called and spoke with them and was told that it was not possible to do this, that I'd have to do it myself. Just can't see cutting a new top up to drill a hole and having to re weld and powder coat it again. Any ideas??
Twist Dynamics Gullwing Top
-
Liability issue for them...a hole hurts the integrity. Why can't you drill the hole?
-
Liability issue for them...a hole hurts the integrity. Why can't you drill the hole?
I could drill the hole, but the the bar coming across the front would have to be cut off for the hole to be drilled, then welded back on then re powder coated. Liability issue, I really don't understand as it is not rated as a roll bar or safety device.
