Doing light mods

Hey all as I am working on Tric LEd chaser lights on my sling a few things I am doing.

1. FZ fuse block
2. Chaser Led around my running lights

3. AMber running light conversion

4. Chaser led underbody

5. Train horn

6. PA system

7. TricLEd 2nd Battery kit.

8. RGB running lights ( though wired to the aux lighting factory switch)

For those that ran underbody LED's is there anything I need to be aware of? Is longevity an issue?

I am going to run 2 separate LED underbody Chaser and regular RGB running lights.

Once DDM has the RGB no dots will run that on the topside.

Plan on running the FZ fuse block in the well behind the driver's side wheel.

Any tips and tricks anyone want to share?

getting it done...

I had to call TricLed one of my strips is not lighting up all the way ( you can see 3 out in the shot of the red headlight.)
and the 3pin to 4 point output isn't working on the controller box. I can plug them into the underbody output and they work fine. So wait for those parts to come in. Then I will do both tracer and regular LED lights at the same time

PA is in and train horn and compressor is mounted just need to pick up a relay and some wiring as I do not want to plug the train horn directly into the horn wiring.

I do have painted panels coming to hide the wiring behind the headlight as well to make it look less ugly.

Got everything installed and buttoned up except the 2nd battery kit. I am considering getting a lift after working underneath this thing. Was a pain in the ass backing up on the ramps. I still plan on putting more LED's for the front and underneath.