I have put the RGB Halo Rings on and have the wires all connected and placed into position. The problem is that I am not sure how to connect the final piece and was hoping someone could help me out!
Need Help RGB Halo Rings install
-
-
Is that powering all of your halos? Rgbs should have way more than just a hot and ground wire connection.
-
That's just power and ground. You may have a matching connector somewhere in your kit with just wires coming out of the back. You'll need to connect to the red to 12v and the black to ground.
-
Don't judge me lol...
Its not official yet. Just wanted to plug in and make sure all is right before I fully tuck away cables.
-
Okay. All your rgb is wired to one controller box right? That quick connector with just a red and a black wire is hooked to a box that is then run to all the halos?
-
Please forgive my ignorance, i believe the answer is yes. Each RGB Halo ring has a connector (4 total rings)
I have connected the 4ft extension cables to each ring connector. They then connect to this piece
Its has 4 heads (to connect to the 4 RGB rings) that brings them all to 1 head. Then that is connected onto another extension shown here.
Then finally that is connected to the last piece shown here. -
-
These are the only instructions I got.
Maybe @slingmods can help with some feedback? -
It looks like you're just missing running your 12v and ground to your brain there. The thing marked led controller.
-
I have no spare parts. I've used everything that was included in the packages. Did @slingmods not include the necessary part?
-
I want to turn these babies on.
-
Well you're sitting right on it. Is that connector made to just clamp down on bare wire? You may just need to run wire in to that sucker and clamp it down.
-
Hello Mateo, you need to strip some primary wire and run the Red terminal to +12V on the fuse block and the Black Terminal to the Ground Bus and insert a fuse across the bridge to complete the circuit in either the full time 12v position or ignition based on your power preference. If you do not have primary wire.. i'd be happy to mail some out to ya! Let us know.
Thanks!
-
If you didn't get it done, I have some available time this afternoon and can assist.
-
-
@Cameron Roberts @slingmods @WraithSS is this what I need? The red and Black
-
Hah yes, but you'll only need a few inches of each.
-
Lol excellent. Will save the rest for future projects if needed.
-
Don't forget to post pictures of them lit up!
-
@Mateo Yes those would be what you need! and like @Cameron Roberts said, don't forget to post the pictures of them lit up!