Getting Speed Bleeders -- what is the thread pitch for the M10 bleeder bolts?
Thanks!
M10 Caliper Bleeder Bolt Thread Pitch?
-
Getting Speed Bleeders -- what is the thread pitch for the M10 bleeder bolts?
Thanks!
I've been trying to figure out what the bleeder size(s) are also. Had them on my Goldwing and they made bleeding a no brainer. Please let us know what sizes you buy. A link would be good.
-
Getting Speed Bleeders -- what is the thread pitch for the M10 bleeder bolts?
Thanks!
It is M10x1.25
-
Getting Speed Bleeders -- what is the thread pitch for the M10 bleeder bolts?
Thanks!
Never heard of these things. Always had someone else pull the lever, open the valve, hold the lever, close the valve. Repete. Then I got a hand held vacuum pump and thought it was great.
Now this, I have a set on order! What next? Something that could cook a baked potato in minutes!
-
Never heard of these things. Always had someone else pull the lever, open the valve, hold the lever, close the valve. Repete. Then I got a hand held vacuum pump and thought it was great.
Now this, I have a set on order! What next? Something that could cook a baked potato in minutes!
Are they for the front and is the rear the same size?
-
Are they for the front and is the rear the same size?
Good question, not sure, but they are on the way. Hoping they are all the same. $16 + change for a set, one time use will pay many times over. If I find they are not the same across will need to purchase other. I found that 10mm X 1.25 wasn't a common size. Got them through Walmart. Couldn't find on Ebay, most were 8 x 1.25.
