back that thing out, wash it off, and go for a ride!
My wife sometimes whispers the same thing to me...
back that thing out, wash it off, and go for a ride!
My wife sometimes whispers the same thing to me...
That is Buddy, pretty sure he mainly just comes to work for the food
Me and Buddy have a lot in common.. I go to work so I can eat as well..
Our Faithful guard dog protecting a project we are working on
Well are you going to give the name of this foof?
On the 2020+ engines there is a gasket that can be swapped over to the new intake and valve cover. On the ones we powdercoat we do not supply a new gasket, not sure if Mitch is supplying one or not though. They are very pretty though powdercoated - https://www.ddmworks.com/2020-…take-Manifold_p_3038.html
Well it looks like I am swapping over the gasket! Thanks for your response.. again ... ( I Also ordered it through DDM)
Has anyone purchased the Powdercoated intake and valve covers from Rev Dynamics? Need to know if I need to order a gasket kit or if they include it.
I feel the cold today....
This is our upcoming week too.
we would say that's colder than a witch's tit...
Thank you if I Need more assistance will reach out to you guys! FYI ya'll are great!
Just for closer ( pun intended). Dave was spot on! the pins were not engaging.
You can see them through the front top grill opening and the bolts where not set out long enough by a half-inch each. I grabbed a couple of washers and removed the pin added washers and tightened it back down ( with a little bit of blue ). I also put the bolt on the back of the pin as well.
It now closes as expected..
Dave@DDMWorks is my hero once again! Thank You!
Sounds good, if you have any questions while looking at it, we have the techline with us after hours 864-907-6004.
Thank you if I Need more assistance will reach out to you guys! FYI ya'll are great!
Not sure if you figured it out by now, but in the one picture showing the silver latch on the Slingshot frame, the hood looks like it is still not latched in the pic. You can give us a call also at 864-907-6004 for tech support or email direct to - Dave@ddmworks.com
It felt like it was engaging and was hesitant to push any harder will take another look when I get home from the "job".
Bumper hood stops?
bump stops are not even touching.
Question for those that have installed the hood extensions. My hood is now sitting about 1 inch higher and not close to lining up with the front bumper. Especially on the driver's side.
How has everyone adjusted the hood? or bumper? There are no real adjustment points on the hinges themselves.
I can snap some pictures if it helps tomrrow.
almost forgot these...
its a super tight fit on the silicone intake tube by the alternator.
parts are backing up over here...
Has anyone seen this crazy ride?
Thats unique!
to be installed this weekend.
I have so many small mods I need to install like these. once i get em and install will put it on "goodies" Mods thread.
well mine shipped any way.. lol..
yea - I'm not spending $55 to hide the silicone - frankly I don't think it looks that bad
but... all the cool kids bought one!