I have one on order. Thanks for all the help!!!
Posts by Mall313
-
-
Did this happen while driving or removing it......
while removing it. Like a dummy 🤦🏾♂️ This is the video of a similar looking caliper.
-
I just found a rebuild video for a caliber. That part is the hand break mechanism. And has to be removed from the inside.
-
Some up close pictures after I removed all the brackets. Not sure if this is like a stud with treads on both ends. Maybe a should not have said “bolt”.
-
Thanks I’ll give it a try. This is how it should look
-
Can this be repaired or will I need a new caliper? The ebrake bracket bolt broke.
-
-
I got my 2015 looking brand new. I had to make some brackets and cut the originals. Also I had to trim the nose edges to get the center headlight to fit.
-
You can also order these brackets for a 100% factory conversion. I have them but they are not really needed. A small zip tie will work just fine. They allow the upper drl’s to move up and down(or float). If you use the bracket you use the foam tape on both sides. All of my parts are oem and the fit is perfect.
5266140-329 left hand
5266141-329 right hand.
As far as the lower panel accents you will also need”
4 clips(speed nuts) 7081305
4 bolts 7520909
2 tuflock rivet 7661855
For the bottom led accent lights I ordered 4 of these so I could make a plug and play style harness.
https://www.ebay.com/itm/Delph…ksid=p2057872.m2749.l2649
neverenoughtime would you share how you wired up the lower LEDs. My 2015 had two connections so I added the Canadian lights. I wonder could I use that connection?
I ordered all the parts should be here soon. Thanks again I saved a ton of money and I prefer Oem parts!!! -
Great post I’m going to give it a try. I noticed you posted the upper LED part number for the lower LED lights
Lower LED
2414079 & 2414080