Posts by ghostrider
-
-
TWO-CENTS.gif"Have No Fear"
we have experienced that same noise - and it is coming from the Drive-Shaft - it is normal - the driveshaft has, where it connects to the rear of the transmission - has a slip yoke (Constant Velocity Joint) that allows the drive shaft to become long & short
if you were were to go underneath your SlingShot and rotate it -you would feel some movement and that "Distinct Clunking Noise"...................................... tom n carol
cool! thanks Tom , after had to check the drive shaft , it seam doing the noise than i hear , so everything it's normal.
-
hello all , my 2015 SS 3000 km doing strange popping sound from somewhere at the rear end when i release the clutch very fast at first 3 gear i think so.
adjust the belt by myself witn 10 lb gauge litle bit loosen than fab recommandation but doing the same noise again.
before than i adjust the belt it was more than 1 inch free play by hand and now has 3/4 inch by hand ,
and had 17 mm with 10 lb pressure gauge for now , so little bit loosen than recommandation.so do you think , only 1 or 2 mm loosen the recommandation can doing this popping sound again.
i compare the belt tension with the one in show room at the dealer and it's seem the same by hand so 3/4 inch freeplay.
???????????????????????????????
Hummmm! so sorry for my poor english , i'am from Québec , Canada.
torque axel nut at 250 lb and put in locktite and put locktite on belt pully too last summer (2015) and put a cutter pin across the axel nut and axel shaft .
Axel bearing dosen't any noise and don't had any play.