Posts by brianmjones

    Have the following code tripping the CEL, 0-65551-5, which is knock sensor open. I replaced the knock sensor and did have the ECM unplugged for 6+ hours prior to doing so. I have tried the key on/off 5 times as suggested, have added octane boost to rule out a bad tank of gas, and have taken 7-8 rides making sure the engine came up to operating temperature each time. The CEL remains. Is there anything left to look at before heading to the dealer to have them plug in to clear the code?

    Here' the full list with part #'s of what I am looking for.


    SUBSTRUCTURE-HOOD 5452637
    HOOD-PANEL,MAIN,BLACK PEARL 5452895-666
    FENDER-FRONT,LH,BLK PRL 5439640-666
    PANEL-ACCENT,LH 5439642
    WING,FRONT,LOWER 5454386
    WING-FRONT,UPPER,RH,BLK PRL 5439700-666
    WING-FRONT,UPPER,LH,BLK PRL 5439699-666
    CAP-FUEL,NON VENTED,BLK PEARL 2521278
    TRIM-CONSOLE,UPPER 7179156
    COVER-FUSEBOX,72WAY 4014047
    CONSOLE-CENTER,RH,BLK PRL 5450037-666
    SIGNAL-TURN,FRT,LH 2411872
    ASM-HEADLIGHT,OUTER,LH 2412877
    POD-HEADLIGHT,LH 5452307
    WELD-HINGE,FRT,E-COAT 1019292-329
    WELD-MNT,HINGE,E-COAT 1019289-329
    WELD-TUBE,LOWER CLIP,E-COAT 1021531-329
    BRKT., MOUNT, FRONT UPPER WHISK, E-COAT 5261028-329
    BRKT-HEADLIGHT,BZL,LH,ECOAT,BL 5259841-329
    WELD-FRONT SUPPORT,BLK E COAT 1020623-329
    WELD-MNT,RADIATOR,UPPER 1022370
    OEM Polaris PANEL-REAR,HUMP,DECK,LH 5452130
    OEM Polaris PANEL-REAR,HUMP,DECK,RH 5439968


    Also the factory radio tuner (not the screen portion) and the brackets/mounting hardware for the screen.

    I purchased a low mileage wrecked 2016 SL and am searching for the parts needed used before purchasing new. Yes, I know this is a risky endeavor, however this was the only way I was going to be able to own an SS. Just a few hours in with minimal spend, and I have already corrected the mechanical and electrical issues that it had. It runs, drives, steers, and stops. Now I need to corrective the cosmetic issues. Finding these parts used will accelerate the time line to get it back on the road. Below is the list of what I need (pic attached for reference), please message me if you have any of them you would like to sell.




    • Hood, both outer and inner structure
    • Both front turn signals
    • Both headlight assemblies
    • All 3 wheels (18”/20”)
    • Both trim panels under the roll hoops
    • DS fender
    • Bumper/splitter, both side wings and the lower main
    • Hood hinge/bar
    • All of the sub frame forward off the A-arms; radiator mount, front support bracket, lower tube, headlight brackets