Posts by wrenchmn
-
-
Should be a great pleaser .
-
I like a top as an option . I see a lot of folks throw a towel over the seat to slow heat absorption.
Just my HO -
"Good" is an understatement !
You are correct, I did understate the appearance .. Noels ads and Rab's logo look Great !!!
-
See logo but not sure when it showed up. Looks good though
-
Welcome and Enjoy
-
I wanted to post these pictures on this forum. I took out the roller/needle bearing. It was pressed in .611 from the outside surface of the axle hole. End result center of the bearing for drilled and tapped hole was 1 1/16" from the outside surface of the axle hole. Replaced bearing and tried zerk. Grease went right where it was suppose to. I did place the bearing hole directly over zerk hole. This is what I plan to do. Jack up rear end put in 1st gear so tire turns slowly. Then one trigger pull of the grease gun. I plan to do this every 5000 miles. No down time during summer riding for me! Thanks Polaris for the expensive ass piss poor bearing design!
Great work and Great idea . Thanks Travis
-
I have a madstad tinted windshield and I'm thinking about selling it and get a tinted ripper from Polaris... Would like to know what you guys think... Good idea or not?
The madstad looks new. No complaints just think the ripper looks real cool. Haven't seen one in person yet.Since I installed the madstad unit I never bothered with the adjustment. Never felt the need to adjust it based on wind..
Look forward to your comments.
I had the 11 and have cut it down to 9 and about to cut it to 7 in order to look over all the time and not thru it. Not bad to cut if you take it off and tape the edge you are cutting
-
a little slow on up take,,but found this place...looking forward to some ss info and meeting members.
Welcome to good side of the tracks..
-
Had to hit the dislike on FITS Brothel Bride since there was no Puke Button...
-
A word from our Sponsor brought me over. I've seen the light!
-
Just west of Atlanta (Powder Springs, Ga)
-
-
Grandaughter and me at water rock knob and a Fun SS Camaro Project all from 2012
-
Top Pic is Me and Wife on the Dragon
Second Pic Down is Oldest Grandson 13 Yrs and My Dad at 80 Yrs
Brother and Me -
I would do all I can metro Atlanta area.
-
I can relate to that. Mine still has the factory air in the tires.
I thought you said you had Nitrogen in your tires ????
-
OK... Here is the question if you have only been modding with your own stuff is that the same as modding with someone else's stuff?
Or am I just saying with myself and still a mod virgian.Signed ... So confused?
Hey Duck, You Sir are one of the Mod Pros from what I have seen. You have used yourself so much you can't be a Virgin
You have done cool stuff on your own.. -
Once you start ,you will have a tough time putting the brakes on. Go get some boost to break in that new rear tire .
-
wrenchmn here and wrenchmn on the other places as well.
2015 Slow Red SL per all those who started with a Grey One
Hahn keeps me out of the Slow Lane