So the outside water line connected to my stage 1DDM works turbo is too close to the frame, I am running the original 1320 header so do you think if I tried a different header it might pull it away from the frame a little bit? I have about an eighth of an inch clearance but I’m afraid with the torque of the engine it’s gonna smash that waterline against the frame. Any help would be greatly appreciated
Turbo clearance
-
How much clearance is needed?
Dave@DDMWorks "@" will get Dave's attention and he should be able to get you a good answer.
-
The crew at DDMWorks have been great to work with. I've had only minor additions to my Slingshot but they are always there to help.
-
-
Thought this thread was going to offer up a good deal on a turbo...
Who else was disappointed? 😆
-
Lol, that’s why I looked....
Sent from my iPad using Polaris Slingshot Info
-
so what was Dave's solution to the clearance issue?
