I have a question on a hydraulic system particularly a braking manifold on a hydraulic motor. This is one of my stump grinders that has developed a problem and I have never seen a braking manifold and looking for suggestions before I just start replacing everything. If anyone has some knowledge here let me know please. What is happening is when I engage the motor it is not getting flow and deadlocking and wanting to stall. I have torn the motor apart and it's fine, also all other hydraulic movements work except the motor. See the attached diagrams, as stated the cutter head motor Fig 2-2 will not turn and I am thinking the braking manifold Fig 5-5 is the culprit either the electric solenoid or a stuck valve.
Hydraulic help needed
-
-
Well, lot of places that system could fail.
The messy redneck method to be done outside would be to crack lines.
Assuming the cutter head rotates freely...
I would crack the hydraulic return of cutter head motor to check hydraulic flow.
If good, problem is down line from there.
Not much help, but it's a start.
Solenoids click when energized. Maybe use a jumper to energize the solenoid with the engine off.
-