Polaris Slingshot Stock Radio Faceplate Screws

Personally I would just replace them with some stainless steel allen head screws. My local Ace hardware has a great selection of such things.

Quote from Akfinest 1

I have taken the four (4) screws (bolts) that hold the Polaris Slingshot audio panel faceplate several times for different mods. The head of a couple of the screws are beginning to strip and it is getting harder to remove them. Have someone replaced these screws with something better or do I need to order these from Polaris?

Ace is the place with the biggest selection of any other place that I have found except Amazon. The last special screws that I ordered from Amazon had to come from China and took about 2 months, I could not find them anywhere else.

Per Polaris, they are part SCR-HXBH-M4X0.7X30 10.9 ZPB so looks like m4 x 30? https://www.polarispartsmonste…s-49slingshotsound14sling

From the pic, looks like they are a security hex or torx screw (has that small raised bit in the center), so you need a hex that has a hole in it. Looks like this if you don't have one : https://www.ebay.com/itm/Titan…-Pack-of-13-/332718327933

Of course, they make the same for torx.

If you knew all of this, sorry, trying to educate in case people don't know.

Quote from wokka

Per Polaris, they are part SCR-HXBH-M4X0.7X30 10.9 ZPB so looks like m4 x 30? https://www.polarispartsmonste…s-49slingshotsound14sling

From the pic, looks like they are a security hex or torx screw (has that small raised bit in the center), so you need a hex that has a hole in it. Looks like this if you don't have one : https://www.ebay.com/itm/Titan…-Pack-of-13-/332718327933

Of course, they make the same for torx.

If you knew all of this, sorry, trying to educate in case people don't know.

Display More

so, like I said, run to Ace and pickup 4 m4 x 30 SS allen head screws - probably cost you less than than just one from polaris and it will look better

Quote from wokka

Per Polaris, they are part SCR-HXBH-M4X0.7X30 10.9 ZPB so looks like m4 x 30? https://www.polarispartsmonste…s-49slingshotsound14sling

From the pic, looks like they are a security hex or torx screw (has that small raised bit in the center), so you need a hex that has a hole in it. Looks like this if you don't have one : https://www.ebay.com/itm/Titan…-Pack-of-13-/332718327933

Of course, they make the same for torx.

If you knew all of this, sorry, trying to educate in case people don't know.

Display More

Those bit sets are the best to have in your tool box, I have all three sets. Northern Tool has them if you have one close by. They also have a very, very stubby rachet ( 1/4 in.) that works perfect with these sets, it is maybe 3 inches long. I used it so much I went back to get another one and now they have the same thing with 1/4 on one side and 3/8 on the other, so I bought that one instead.

I just went out to the garage and looked at mine and they do not have the raised thing in the center . 2.5mm allen wrench fits right in