Dealer installed new transmission, put engine back in and this code popped up, I’m over 2 hours away from there and they say it runs fine but they don’t know how a supercharged engine is supposed to run, they check wires and plugs... any ideas?
Code 1089. Cam phase
-
Make sure the cam sensors plugs are securely installed in the correct position.
Disconnect the harness from the ECU for 10 minutes. Reconnect and start it up.
See what happens.
There is no difference with a SC than normal. -
This ain’t good, on techs test drive, it lost power and died 100 yards from dealer, they had to push it back to shop.....
-
Damn... Seems like more Slings are starting to just give out... Interesting to see what it ends up being Joe!
-
Hope they get you figured out man. Rootin for ya!
SSREAPER
-
Well, after drive by to dealership this morning and looking over my SS, they blew my built engine up, locked it up solid.....
No idea what they did wrong but it’s gonna be a costly mistake....all over putting a new transmission in under warranty....
-
Ouch. Sorry to hear that...
-
Well, after drive by to dealership this morning and looking over my SS, they blew my built engine up, locked it up solid.....
No idea what they did wrong but it’s gonna be a costly mistake....all over putting a new transmission in under warranty.... You do know this is the 4 of July....not APril Fools Day....Please tell me you are kidding!! How the hell on earth can they blow up a BUILT motor in an attempt to replace a transmission?!? Unless they drained the oil and forgot to refill it...then it would lock up solid like you said!
Please tell me they are paying for the repair and not you!!!
SSREAPER
-
Man that sucks. At least it happened in the winter for Texas. You will have the good weather right around the corner by the time they figure it out.
