May not be calling them the correct term, but have searched this forum and couldn't find help that I am looking for. I am sure someone has experience with this.
I am dealing with an individual who is going to make me some custom puddle lights. They project an image onto the ground when switched on. I would like to mount them on the underside of the mirror to project on the ground directly below them on each side of the Slingshot.
My questions are:
1. When drilling into the mirror housing, is anything inside that I could damage?
2. Is there a way to remove mirror housing from support arm? I looked it over pretty good and I may be blind, but couldn't see a way.
3. Lastly, can the mirror be removed to make running wires easier?
I know this may seem kind of simple to some, but I get a little weirded out when drilling on the Sling!!! Any help would be appreciated and Thanks In Advance!!
CDCAMEL6