- Saw this in another forum, lol. Figure I would try it myself. Pretty easy since there is already a line to cut on molded in the factory guard. I used an angle grinder with a cutting wheel on it to make easy work of the big chunk, then put on a flapper wheel to fine tune it to the line. Turned out great in my opinion and personally looks better seeing the whole sprocket. Would look good with a hub lock on there I'm sure. I bought a trim panel push pin to go in the unused hole at the bottom. I cut it down to only about 1/4" was in the hole.
Stephen
Not sure why my pic won't show up now. I posted a couple last night with no problem.