When inserting the MAP sensor that was sent to @jaytizzl in his kit into the intake manifold, we could press with a lot of force, but the MAP sensor would never seat all the way down to the bottom out. The reason we found in this case, was that the black rubber piece installed on this MAP sensor would balloon slightly when installed and prevent the MAP sensor from fully seating -
We did contact Henry this morning to let him know what we found also.
Hope that helps, please let me know if you have any questions,
Were you able to click the sensor into place? I installed the MAP sensor and I'm starting to think I may be responsible for @jaytee's motor going pop...