Ok so i hooked up a set of slingmods front blinker wire harness , a set of slingmods eye brows & a set of lower brows LEDs all with blinker modules........on a 2021 slingshot R....... now for some reason when they are all on and working.........they work fine but then they all cut off and the outside slingshot light, the only thing on is the slingshot center light ........and it cuts off the brake light, so thats on the same circuit i see, the strange thing is , its not blowing a fuse , just cutting em off, when you shut the slingshot off and back on everything works fine but then cuts off after a few minutes..
Ok so an electrical issue........
-
-
Have you contacted slingmods.com? sometimes they can be helpful other times not so much. Worth a shot. I don't have a 2021 so can't help much but good luck on this. I'm in the middle of a massive stereo upgrade on my 2016 SL. About $4K worth. boom! Stimi helped.
-
I have my upper/lower brows and wheel lights running off the same blinker module and it works fine. Only issue is with 4 ways and no key on it won't flip the relay back and I hear some inline resistors will fix that, but haven't done it yet. I wonder if your issue is with multiple relays/modules?
-
Well of course slingmods dont answer their phone , i also see if i run just the lower strips no problem but all 4 with seperate blinker modules causes it to trip
-
Same problem when I tried to call them. It also took a few days to respond to a message.
-
I also tried running 2 strips on one side with only one blinker module, same results .....im starting to think these 4 strips are to much to handle on this circuit.......
.......when i run just the lower , everything fine hasnt cut off at all, so far
-
There is a video about adding resistance in the flasher wiring. The flasher detects load or something and it’s not meant to handle a lot. That’s why you add resistance.
-
I also tried running 2 strips on one side with only one blinker module, same results .....im starting to think these 4 strips are to much to handle on this circuit.......
.......when i run just the lower , everything fine hasnt cut off at all, so far
LED bulbs use significantly less amperage than conventional bulbs. Adding several different LED setups to a single flasher may well alter the load to the point that the flasher may not function properly. I don't know what the electrical requirements are for a normal incandescent bulb flasher, but You might see if a flasher designed for old-school bulbs might work if you can't find a better answer.
-
Well im getting it back in a few days for a exhaust install and will check each strip and harness seperate, slingmods emailed me back about checking the harnesses and that it might be a bad one , ill see...
-
I added resistance to my accessory flashing lights
-
I added resistance to my accessory flashing lights
Any pics & is this on a 2021
-
I added some 100 ohm resistor into the flashers.
-
Any pics & is this on a 2021
no and no....
I have a ‘15...
they look like this...Not much bigger around than a mixed drink straw...
sam has a ton of videos on his site and one of these could have the instructions in it.....
this is a Sam drawingHe added dash mounted signal indicators....but assume those are just addition lights you want to add....