I just unwrapped my new cover max cover. I was skeptical as to whether it would fit over my roof. With some stretching and pulling it covered the entire SS with the rear fender and two flag poles sticking up. It’s tucked under the front spoiler and it goes down around the bottom curve of the rear tire. The quality seems nice considering it’s made in China. The only down side for me is there are no grommets on either side to attach a locking cable under the SS. On my old cover I was using the cable to just keep the cover from blowing away. Not saying this one will blow away, but you never know and there is always a chance
that the cover could grow legs.
this is from the rear looking toward the front.
You can see my brick hanging from the loops they provide. There is a strap attached to the other side. You can see my locking cable through the loops. I would have liked a sturdy grommet near the bottom in this area to feed the cable through.
a shot of the roof and the bulges from the flag poles near the upper right corner.
also you can see the cover doesn’t go all the way to the ground. For me that’s a plus. So air can circulate under the SS to dry up any rain or condensation. This should prevent rust from forming. I had serious rust issues after one winter with a two wheeler that didn’t have sufficient air flow with a similar cover in first winter I had it.
The rear wheel is completely covered.
the driver side brick and strap. I will never use the strap.
you can see the cover wrapped under the front spoiler.
this is the driver side mirror bulge. I expect those to be a major weak spots after some serious summer sun.
Roof shot
Flag poles
Rear fender
old cover with the air gap I maintained every winter.
This white cover was dried out by the sun. I can’t wait to see what the black cover will do from the UV rays.