There is a back hanger, not sure how that should attach. How much clearance should i have with the rear Y pipe from the SS. Could somebody look at these pictures and tell me what i need to please.
need guidance with WP 2.5 Dual Exhaust.
-
Remove the battery cover and install in the hole at that location. Used to support the rear just before it bend and rises up to the Y section.
Youtube Jeff’s install video for a complete walkthrough.
-
@Jeff Welter? Can you help a brother out here?
Thanks Joey! Looks like you answered as I was typing.
-
clearance between SS and Y pipe should be between 3/8” and 3/4”. I prefer it as close as possible to avoid rubbing the rear tire.
-
-
@Jeff Welter mentioned the 2017 install was a tad different. He will
Have to chime in. -
I'd suggest calling Jeff and or PMing him on BookFace. I get faster response that way.
-
Contacted @Jeff Welter again outstanding customer service. Installed my hanger can anybody tell me if its correct or any input from you guys and gals.
-
on my 17 the rear hanger goes up and down not sideways. Put in the bolt the goes inside the frame hole and let it drop down straight then attach it to the pipe. Mine is 2 inch but I think it is the same.
LC
-
-
on my 17 the rear hanger goes up and down not sideways. Put in the bolt the goes inside the frame hole and let it drop down straight then attach it to the pipe. Mine is 2 inch but I think it is the same.
LC
Thanks. I have a 17 also. I would assume the clamp bolt that goes around the pipe is down also.
-
I have one already, so I will be prepping for paint and installing it also. I am glad I purchased it awhile back.
-
No the bolt on the clamp should be at the top, the weight hangs on the strap.
LC
-
Just checked to see if I had a picture, I do but not with me. Sorry.
LC
-
Just checked to see if I had a picture, I do but not with me. Sorry.
LC
No worries thank you for the advice, much grateful
-
Sorry. Im just now seeing this. I think We spoke earlier on phone but not sure. 573 703-4308 my cell. Call anytime if you have any problems or questions still unanswered.
Sent from my iPhone using Polaris Slingshot Info
-
It appears you need to twist the third pipe wow somebody holds the two silencers without clamps on them with their hands as you twist the third pipe The Y section will move closer and further from the plastic
Sent from my iPhone using Polaris Slingshot Info
