I have come up with a rear protection plate for the flat, plastic panel immediately in front of the rear tire. This area accumulates a lot of grime and tar from the road and is difficult to clean, as well as being rather plain looking. The plate is cut to fit from .060 diamond plate and attaches with 3M tape and two auto-body push fasteners so two holes will need to be drilled in the rear panel for installation. The bottom edge is just above the 3 screws that are used for various add-ons. The one pictured is powder coated in wrinkle (flat) black to blend in with the rest of the rear plastics. I also have gloss black/clear coat and red/clear coat to match the 15/16 pearl red. I'm sure that with research, colors can be found to match the sunset red, orange, blue fire, navy blue, midnight cherry, etc colors but I have not done that research because mine is pearl red.
So here's the deal. In order to get the best pricing on material and powder coating I need to process them in batches, therefore I am offering the pricing and options listed below. If you are interested, shoot me a PM with the color you would like rather than clutter up this thread and then I will have your contact info to respond to. I will not ask for any commitments or payment until I have them on hand ready to ship . I can work with people for pricing on non batch-produced requests.
Bare Diamond Plate: $75 shipped (ready to paint)
Bare Diamond Plate + Clear Coat: $80 shipped (finished look ready to install)
Powder/Clear Coated Gloss Black: $90 shipped
Powder/Clear Coated Red: $90 shipped
Powder/Clear Coated Orange: $90 shipped
All shipped to lower 48. Other locations quoted on request.
These will come pre-drilled for 2 Polaris style push auto-body fasteners (included). They will have 3M tape attached, ready to install. Thanks all!