I was testing wires just so I could find where they run, and which wires are which.
All of a sudden I lost my left turn signal entirely. 
What did I do?
Ok .... what did I do?
-
Display More
I was testing wires just so I could find where they run, and which wires are which.
All of a sudden I lost my left turn signal entirely.
What did I do?
Sorry, I can't help you, but I'm following this because it sounds like something I would do.... and then blame on K2.
-
Sorry, I can't help you, but I'm following this because it sounds like something I would do.... and then blame on K2.
-
I'm not sure what you did, or how to fix it. But this may or may not help.
-
-
A couple people told me the Slingshot has resetting fuses. Maybe that is all you tripped. Basically the ribbon in the fuse warps when heated, disabling circuit and returns to normal when cooled.
-
Yes, relay or fuse thingies... When I was wiring up my switchbacks to an additional relay, there were times I'd try a sequence and it would cause the blinkers to work once, then cut off completely until I turned off and then back on... Other side would work fine.
-
I had the same issue when adding LED strips. Used a LED test light after, worked ok. Draws less current and didn't trip the protective device (which as others said, reset itself).
