Insatllation of 1320 Performance Slingshot exhaust with build in Anti-Reversion chamber & Cone silencer

Have you see this ....

sent from my FAST red slingshot

Quote from mytoy

Do i have to remove any panels and which ones and how?
This is the one I get.

Reviews on 1320 website seem to indicate side panel removal

sent from my FAST red slingshot

Quote from mytoy

A little more then what I expected,
Thanks @Ross

The reviews say about 20 minutes to get the side panel off. I have faith in you sir - you got this.

@Painter has a bunch of helpful videos too

I'm sure others on here can give you much better tips

sent from my FAST red slingshot

Twenty minutes is a bit optimistic. I just installed this same system in mine. I watched a Slingmods video where Joe (Slingking), shows which bolts need to be removed to take the side panel off. It wasn't listed under the 1320 exhaust, but a different one. Getting the panel off isn't the hard part, getting it back on is. I wound up tapping all the holes where the bolts go, as well as the u clips. It's probably not needed, but these are really cheap screws holding it together. It made reassembly go smoother.

Removal of the entire side panel is not necessary. You only have to remove enough bolts/screws to flex the panel out of the way. A new exhaust can be dropped in a Slingshot in about a 30-40 minutes with the proper tools. You got this brother.

Been looking at this exhaust for a while and thinking about getting it next month. Was wondering if anyone has it yet and what are your thoughts on it? Ground clearance was my biggest concern but I also saw a review that the system turned brown after running a while. I know my 1320 header did and I'm fine with that and even the stuff under the hood and bike doing that but the stuff on the rear of the bike turning brown would be a big no no for me.

If it is stainless steel it will tarnish, colors of blue, purple, and brown. You can polish it on the regular, but that would be very time comsuming.
Looks like the one that the OP is referring to does not exit at the rear of the Slingshot.

Ceramic coating would fix this @MISC, @WraithSS?

I just put my side exit 1320 exhaust on this weekend make sure when you're done wiped it all down with alcohol so it looks good it doesn't burn your fingerprints into it make sure you remove the whole entire side panel it makes it much easier I've done it multiple times

Report back on the under frame experience @supermoto292 when you can!

it looks like there is pretty good clearance, but time will tell. Hopefully with my new baffle I can get the noise and drone down

Video clips of the exhaust please!

Sent from my iPhone using Polaris Slingshot Info

The exhaust looks good make sure you go to the auto parts store and buy a copper gasket for their o2 plug to make sure it doesn't fall out when you have to go by the header gasket

I would love to know how the clearance is at speed. Is this something that will just be a track bump ?