@lrobbi no problem, if you could PM me the dimensions of the wing I could find out if it will fit the same as the Alpha spoiler!
Thanks, I will do that...I just got back in town from Sunny Florida...I will send you a PM this evening after work. Thanks!
By the looks of the picture it will not fit
However if you work something out I would have interest in one as well. I think my wing is 67" wide
Much wider that the back of the SS
@MACAWS if you could send me over the official dimensions of your wing I could see if I have a cover that will work with it!
Here you go
Width of the wing = 61"
From the front of the roll hoop to the furthest point back on the wing 25-1/2"
From the deck to the top of the wing 12-1/2" (measurement taken on either side of the fin)
Here is a photo.
Just a side note - I have a Polaris cover and we had the cover notched for the 2 vertical supports on the wing.
But I do not think any 2 wings are the same - This is the wing Berts was offering
Thanks
Mitch
All orders will be shipping out today! Thanks for the continued support everyone!
All orders will be shipping out today! Thanks for the continued support everyone!
Looks like you guys "got it covered"... 
I had the three's da life cockpit cover and never could get it to install correctly after I put my madstad on. My fault, not the covers as it worked well and folded small. So I thought I was going the less expensive route when I ordered by covermax cover. Covermax cover goes on great, fit's well, easy to install. It however folds up like a map and takes up as much room as a person! I loved the Polaris cockpit cover, but didn't want to spend the extra money for it. This one looks like it covers all the bases!
any word on fitting your winged friends?
I purchased one and received a confirm from Fed ex. I read there is no felt or padding on the underside for the windshield. Any heads up if I use spray adhesive on the inside of the cover and apply an old sweatshirt cut out to guard against scratches over that area?
Maybe wash the sweatshirt so it doesn't stink? 
Will these cover work on F4 3 “ windshield?
Sent from my iPhone using Polaris Slingshot Info
Will these cover work on F4 3 “ windshield?
Sent from my iPhone using Polaris Slingshot Info
Hey @HLC45 - We have not tested the Nelson Rigg cover on a Sling w/ a 3"+ F4 shield, however, I think there should be enough slack to still cover the cockpit and not be a problem. If you order and it doesn't fit, let me know and we will take care of you.
Anyone got a pic of this fitted on a alpha wing?
Anyone got a pic of this fitted on a alpha wing?
I don't think it will work with the wing. It covers the windshield, then over the cockpit and the "V" tail section of the rear body. While it's not tight there (pretty much perfect fit) I don't see how it would work with a wing. I used one last summer anytime I traveled. For my setup, it works perfectly.
