Thanks Bill,
We put the amps under the dash behind the factory radio or pocket. I worry about them under the seat because they're so low to the floor it's easy to get water in them. Even a marine amplifier cannot handle 1 drop more water then a car amplifier. The main difference is that a marine amp has a conformal coating sprayed on the circuit board to protect the copper traces against salt air corrosion. So, the higher the dryer in this case. However, we designed an awesome little sealed amplifier just for the purpose. At the CES show 2 weeks ago we release complete plug-n-play mounting solutions for a number of Side X Sides including the Slingshot. They'll be available in under 30 days and we'll have pics to share of the components next week.
In terms of wire routing... Option 1) The best way is to pull the seats and the rear panel around the storage boxes and route up the center cosole. If it's a 15-16 there are a bunch of bolts and takes about 30-60min. the 17+ use a panel clip fastener and is quicker.
option 2) you can pull the rear hoop covers and fish from one side to the other. Pull one of the shoulder bolsters by the seat and fish the wires down the side to the floor then run under the floor panel seam or along the bars by the pods and upto the radio.
Hi! You mentioned that you released a complete plug and play mounting solution. Did you ever post the pics of components?
Sent from my iPad using Polaris Slingshot Forum mobile app
We don't control parts once they hit dealers so we're not sure of their status but the ones you mentioned are Top Notch so they're doing everything they can to take care of you guys. I believe if your not in this production run, then you'll be just about 2ish weeks away from your parts. Again thanks for your patience, I promise they're worth the wait.
2 WEEKS!! If I only had a speaker pod every time I heard that!
Can you hear me know 
